From the report I want you to work on the recommendations part Chapter 4. and the conclusion Chapter 5. When writing the Recommendation and conclusion think of the following; be written to relate directly to the aims of the project as stated in the Introduction indicate the extent to which the aims have been achieved summarise the key findings, outcomes or information in your report acknowledge limitations and make recommendations for future work (where applicable) highlight the significance or usefulness of your work. Conclusions Show/hide lecturer’s comment 26 Show/hide lecturer’s comment 27 Show/hide lecturer’s comment 28 Show/hide lecturer’s comment 29 Each of the two bridge designs presented in this report fulfil the criteria specified in the project brief. Both designs incorporate round piers on piled foundations, which are used because the soil conditions are unknown and possibly unstable. Design 1, a simple composite I-girder bridge, has the advantage of being made of steel and thus has longer spans and fewer piers. Design 2, a super-T beam bridge, requires minimal formwork in the construction of its concrete deck, is relatively easy to erect and will maintain stability during transportation and construction. In addition, it is more economical to build and maintain. Design 2 is therefore recommended. It offers an affordable overpass with superior durability, and fully meets the requirements of the design brief. Recommendations Always address limitations and suggest how they might be overcome in future work. The excerpt below is from the Conclusions of a report on a project investigating the effect of pulsation on heat transfer in horizontal pipe flow. Show/hide lecturer’s comment 30 Show/hide lecturer’s comment 31 Show/hide lecturer’s comment 32 Show/hide lecturer’s comment 33 Experimental results showed that pulsed flow without flow reversal had no significant effect compared with steady flow. Preliminary experiments with reversed flow, however, clearly indicated increased heat transfer.This is likely due to the large disturbances in the hydrodynamic boundary layer when the flow changes direction. Further research is recommended to determine the maximum achievable enhancement. It should be noted that the experimental results do not agree with the theoretical equations. This may be due to the deposits which developed inside the pipe, or to inconsistent thermocouple temperature. Therefore, regular inspection of the test rig is recommended. For a very long report, it is acceptable to present the conclusions and recommendations in point form: The prototype robot courier presented here has been shown to be capable of delivering documents autonomously in an office environment. It has demonstrated the following components of mobile robotics: Localisation: The Kalman filter-based localisation algorithm achieved sub-centimeter accuracy under normal operating conditions. Environment modelling: The occupancy map was updated dynamically to include obstacles not included in the original map. Path planning: A distance transform-based path planner using obstacle transforms produced a globally optimal local entrapment-free path to the goal. The current Recommendation and conclusion are far from good. In the recommendation part, you will notice words highlighted in yellow. These are quick remarks of the professor. Try to avoid those mistakes and be as clear and concise possible. Try not to generalize the report. Use academic articles when sourcing in APA style! For any other questions make sure to reach out to me.
https://pay-for-my-essay.net/wp-content/uploads/2021/03/LOGO.png 0 0 Nick https://pay-for-my-essay.net/wp-content/uploads/2021/03/LOGO.png Nick2022-03-20 23:11:092021-09-22 09:23:09An analysis of CRM strategy at Diamant Centrum